Cabinet Door Rail And Stile Dimensions

It s standard for all cabinets and doors due to the fact that most cabinet grade lumber of any type is.

Cabinet door rail and stile dimensions. I was thinking of using 2 face frame material for the door frames to save milling time but i think it might look a bit dainty. The width of the rails is equal to the width of the door minus the width of 2 stiles plus the depth of the panel groove connection joint on each stile. All joints are created with a rail and stile router shaper bit. Is there a standard rail and stile width for kitchen cabinet doors.

Mullions are the same width as the rails and stiles. Typical horizontal rails are 1 4 inch wide at the bottom of the face frame with 2 inch wide rails between drawers and door openings. There s nothing dainty about that 2 door frame size clint. Typical vertical stiles for face frames are all 3 inches wide.

The basic structure of shaker cabinets is no different than any other cabinet using hardwood face frames which is almost always 3 4 inch thick. For the overlay doors i have been making all perimeter rails and stiles 1 3 4 inches and all middle stile and rails at 2 1 4 inches so i end up with 1 1 4 inch of all of the stiles and rails exposed with my 1 2 inch overlay doors. Forum responses cabinet and millwork installation forum. Calculate cabinet door rail stile and panel sizes enter the values below to calculate the sizes for rails stiles and panel.

Door height inches or mm door width inches or mm stile width inches or mm rail width inches or mm interlock depth inches or mm panel float inches or mm. Can i get away with using a 3 stile and rail for my two doors or is this bad design. The overlay ol is applied to the entire circumference of the door. I plan on using 1 1 2 wide stile and rail for all the drawers.

Arched doors typically add the rise of the arch to the width of bottom rail. Rail width door width stile width 2 panel groove depth 2 for example a 18 wide door with 2 1 4 wide stiles and a panel groove of 3 8. Stiles and rails for doors and face frames are always the same thickness typically 3 4 inch. Clint barden asheville n c.

The panel has a expansion gap pg all around. I am beginning to construct the drawer boxes and drawer faces. I have built the box of a vanity cabinet and have a 1 1 2 face frame on. The choce is totally yours.

Width of stiles can vary for a chunky appearance with smaller panels with 2 1 2 to 3 stiles to a slimmer look with 1 3 4 stiles.