Can I Use A Tile Cutter To Cut Laminate

Besides you need a special chop saw blade to cut laminate properly.

Can i use a tile cutter to cut laminate. The surface layer is so tough that it dulls ordinary carbide blades after just a few cuts. So if the cutter has 8 inch blade length it can cut 8 inch wide laminate. Wear goggles a dust mask and gloves. There are several methods for cutting tiles by hand without a tile cutter using a cutting tool such as a glass cutter or a carbide tipped pencil.

To make a cut you feed the plank lengthwise through the blade line up the cut line with the blade and push down on the handle. When choosing laminate flooring tools there s no pay off for putting up with the loud and dusty operation of a chop saw. You will want to use either a medium or fine toothed jigsaw blade to cut the laminate flooring making sure the exposed side is up while you are cutting. There s no sawdust and no noise.

A laminate flooring cutter looks and works like a paper cutter and it s designed only for crosscutting cutting across the width of the plank. It s a guillotine style cutter which can cut more flooring types including the laminate ones. Yes you can and it should work just fine. Rather than sawing the laminate the cutter chops it using a tough blade and a long handle used to exert downward force.

How to cut laminate tile like board flooring tile should be shaped in straight lines using the proper safety equipment. If you have natural oak laminate flooring with 8 inches wide 4 feet length and 7mm or 27 inch thickness get at least the cutter with a cutting capacity of 3 8 inch or 10mm thick and 8 inches wide. But it should if it cuts tile. Before using any tool to cut tile measure the glazed side of the tile to determine where you need to make the cut.

Use a straight edge to mark the line with an erasable marker. Lastly it is a compact cutter that you can conveniently store in limited spaces. Including the engineered and laminate flooring it s also capable of cutting mdf baseboards lvt flooring foam or rubber tile and even the vct tiles. Use a pencil or chalk to mark where the line you want to separate the board.

Just cut alittle slow the first couple of times to see if the saw can handle it.